Garbin TZ S Use And Maintenance Instructions page 40

TRENCHER
FREQUENCY
Nuts and bolts (on the whole
(Maintenance Sheet N° 05)
Check the tightness of the trench
EVERY DAY
(Maintenance Sheet N° 06)
(Maintenance Sheet N° 07)
(Maintenance Sheet N° 08)
Check the chain, toolholder and
AFTER THE
(Maintenance Sheet N° 09)
FIRST 50
WORKING
HOURS
(Maintenance Sheet N° 10)
(Maintenance Sheet N° 11)
(Maintenance Sheet N° 12)
AFTER 100
WORKING
HOURS
(Maintenance Sheet N° 13)
AFTER 12
TOTAL OVERHAUL OF THE
MONTHS OF
MACHINE AND THE TRENCH JIB
DISUSE
CONSULT THE MANUFACTURER'S TECHNICIAN
Use and maintenance instructions – Spare parts
Rev. 01.2013 - EN (translation of the original instructions)
ROUTINE MAINTENANCE TABLE
WORK POINT
machine)
chain
Open grease nipples
Trench jib gear reducer
screw for wear.
Check the drive belt
Engine
Trench jib gear reducer
Wheels
TAB. 17B (Routine maintenance table)
TYPE OF OPERATION
Check and, if necessary, tighten the nuts and
bolts.
Check the correct tightness of the trench chain.
Grease with AGIP GREASE MU EP1 or similar.
Lubricate with DIESEL oil (Automotive diesel oil).
Grease with AGIP GREASE MU EP1 or similar.
Check the oil level and, if necessary, top up with
AGIP ROTRA MP SAE 80W/90 oil or similar.
Visual inspection of wear.
Visual inspection of wear and tightness control
Change the engine oil with AGIP SINT 2000
(according to the instructions in the attached
manual).
Change the oil with AGIP ROTRA MP SAE
80W/90 or similar.
Check the pressure and wear of the tyres.
THIS MACHINE MAY "ONLY" BE OVERHAULED BY
THE MANUFACTURER OR AUTHORISED DEALER'S
TECHNICIANS.
40
T E Z A
TZ S
Via L.da Vinci,32/B
36034 Malo (VI) Italy