HARVEY HW110LC-36 Instruction Manual page 17

5.4.5. Post the tape scale use the pointer
window (Fig.13)
The machine features a Hi-Low fence with two
pointer windows. As shown in Fig.13, two pointer
windows can be adjusted individually. The pointer
window (A) is for the lower fence while pointer
window (B) is for the high fence. You can
micro-adjust the position of pointer window by
loosening the knob (C) or (D).
Post the Tape Scale
Place the fence as a high fence, slide the fence
against the saw blade, and lock it in place; Place
the front rail tape scale on the fence tube, make
sure it is parallel with the tube, and the "0" end is
directly under the red line on the pointer window
B , lightly mark the "0" location on the tube with
（ ）
a pencil, then remove the fence; peel the tape and
carefully align the "0" mark on the scale with the
pencil mark you made.
Calibrate the Pointer Window
Place the fence as a high fence, as shown in
Fig.13. Slide the fence against the blade, check
that if the "0" mark is directly under the red line on
the pointer window (B), if any deviation occurs,
loosen the knob (D), micro-adjust the pointer
window (B), so that the red line on the window is
over the "0" mark on the tape, then secure the knob
(D).
Place the fence as a lower fence. Slide the fence
against the blade, check that if the "0" mark is
directly under the red line on the pointer window
(A), if any deviation occurs, loosen the knob (C),
micro-adjust the pointer window (A), so that the red
line on the window is over the "0" mark on the tape,
then secure the knob (C).
Fig. 13
5.4.6 Install the switch
The switch differs in different areas:
North America area
European area ：
Asian area F ig.14(B)
：
The list above doesn't cover all the countries, the
actual object shall prevail.
The switch is mounted on the lower right side of the
guide tube by using two sets of bolts which are
pre-installed on the guide tube.
Fig. 14
5.4.7 Install the blade
1. Remove the table insert;
2. Rise the arbor all the way up and set the blade
angle at 0º;
3. As shown in Fig. 15, press the arbor locking pin
by one hand, rotate the arbor until the locking pin
engages with the arbor, then remove the arbor nut
and flange by using a open end wrench.
4. Slide the saw blade onto the arbor, making sure
the teeth face the front of the saw, then install the
arbor flange and arbor nut onto the blade and
tighten.
Fig. 15
14
F ig.14
（ ）
： F ig.14 (A) 。
F ig.14 (B) 。
。