Labtech DigiBlock ED-S Series User Manual page 10

Press and hold
Press and together for 3 seconds again to exit program mode.
How to Setup Program Ramping
Press and
Press continually until
or to adjust the slope of temperature ramping 0~150℃/Hour (Temperature is
ramping).
Press continually until
or to .
Press continually until
or to adjust the keeping time (0~1440min) after reaching the setpoint.
Press and
When and real temperature display alternatively the setup is finished. When
and real temperature display alternatively the unit is running the set procedure. When
STOP and real temperature display alternatively means the temperature program ramp is
finished.
How to Unlock Parameters
Press and
Press one time and LCD will alternatively display LEUL and 1.
Press and hold
Press continually until
and corresponding number.
Press and
When display on the LCD, press and hold
and press or
setpoint is adjusted, release the
together for 3 seconds to enter program mode.
indicated on the LCD. Press and hold
indicated on the LCD. Press and hold
indicated on the LCD. Press and hold
together for 3 seconds again to exit program mode.
together for 3 seconds to enter program mode.
and press one time to enter 3 and LEUL 3.
indicated on the LCD. The LCD alternatively display
together for 10 seconds to enter LEUL 4.
to display resolution 0.1 or 1 degree. Once the
and press
DigiBlock – User Manual
button.
and press
and press
and press
or to .
10