Rinsing; Cleaning; Disassembly - Taylor 432 Operator's Manual

Rinsing

Step 1
Pour two gallons (7.6 liters) of cool, clean water into
the mix hopper. With the brushes provided, scrub
the mix hopper and the mix inlet hole.
Figure 30
Step 2
With a pail beneath the door spout, place the power
switch in the "WASH" position and move the draw
handle to the right. Drain all the rinse water from the
freezing cylinder. When the rinse water stops flowing
from the door spout, move the draw handle to the
left and place the control switch in the "OFF"
position.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
Repeat these steps for the other side of the unit.

Cleaning

Step 1
Prepare an approved 100 PPM cleaning solution
(examples: 2-1/2 gal. [9.5 liters] of Kay-5R or 2
gal. [7.6 liters] of Stera-SheenR). USE WARM
WATER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS.
Step 2
Pour the cleaning solution into the hopper and allow
it to flow into the freezing cylinder.
Step 3
While the solution is flowing into the freezing
cylinder, brush-clean the mix hopper and mix inlet
hole.
Operating Procedures
Step 4
Place the power switch in the "WASH" position. This
will agitate the cleaning solution in the freezing
cylinder.
Step 5
Place an empty pail beneath the door spout and
move the draw handle to the right. Draw off all the
cleaning solution. When the solution stops flowing
from the door spout, move the draw handle to the
left and place the power switch in the "OFF"
position.
Repeat these steps for the other side of the unit.

Disassembly

Step 1
BE SURE THE CONTROL SWITCH IS IN THE
"OFF" POSITION.
Step 2
Remove the handscrews, freezer door, beater
assembly, torque rotor, scraper blade and drive
shaft from the freezing cylinder. Take these parts to
the sink for cleaning.
Repeat these steps for the other side of the unit.
Step 3
Remove the front drip tray and the splash shield.
Take these parts to the sink for cleaning.
Step 4
Remove the rear drip pans from the front panel.
Note: If the drip pans are filled with an excessive
amount of mix, it is an indication the drive shaft
seals should be replaced or properly lubricated.
22
Model 432