BOMANN KS 7315 Instruction Manual page 28

Avoid the installation: Avoid the installation:
Avoid the installation: Avoid the installation:
•
- near heaters, next to a stove, direct
sunlight or any other heat sources;
- at locations with high humidity (e.g.
outdoors, bathroom), as metal parts
would be susceptible to corrosion
under such circumstances;
- near volatile or flammable materials
(e.g. gas, fuel, alcohol, paint, etc.),
in rooms which may have poor air
circulation (e.g. garages).
- Do not expose the appliance any
weather.
Mounting the door handle Mounting the door handle
Mounting the door handle Mounting the door handle
Attach the door handle by removing the
cover caps from the door outer side and
tighten the handle with the delivered
screws into the underlying holes. Put the
included screw covers on.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
The installation to the mains supply
•
must conform to the local standards
and regulations.
Improper connection may cause to an
•
electric shock! electric shock
electric shock electric shock
Do not modify the appliance plug. If
•
the plug does not fit properly to the
outlet, let install a proper outlet by an
authorized specialist.
The accessibility of the power plug
•
must be ensured to disconnect the
appliance from the power supply in
case of emergency.
Make sure that the voltage supply
•
matches the specifications on the rat-
ing label before connecting.
Connect the mains cable to a properly
•
installed and earthed wall outlet.
If the plug after installation is not
•
accessible, a corresponding discon-
nect device must be available to meet
the relevant safety regulations.
Revers Reversing Revers Revers ing the door opening ing ing the door opening the door opening the door opening
If required, the door opening can be
moved from the right (supplied condition)
to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appli-
ance must be disconnected from the
power supply first.
NOTE: : : : NOTE
NOTE NOTE
Ask another person to assist.
•
You possibly need:
•
Phillips screwdriver as well as a thin-
blade screwdriver.
28
screw wrench,