Storing The Machine; Sharpening Metal Cutting Blades - Stihl FR 131 T Instruction Manual

3
Refit the flexible shaft (2) in the
N
protective tube (3) – turn it 180°
from the original installed position
and push it home as far as stop.
Push the flexible shaft fully into the
N
powerhead (4) – turn the shaft back
and forth at the same time.
Line up the flexible shaft – the word
N
"Top" must face up.
2
1
Insert the screw (1) with washer (2)
N
and tighten it down firmly.
FR 131 T

Storing the Machine

2
For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
4
Remove, clean and inspect the
N
cutting attachment. Coat metal
cutting attachments with corrosion
inhibitor.
Thoroughly clean the machine.
N
Clean the air filter.
N
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
Sharpening Metal Cutting
Blades
Use a sharpening file (special
N
accessory) to sharpen dull cutting
attachments. In case of more
serious wear or nicks: Resharpen
with a grinder or have the work done
by a dealer – STIHL recommends a
STIHL servicing dealer.
Sharpen frequently, take away as
N
little metal as possible – two or three
strokes of the file are usually
enough.
1
1
2
2
1
2
Resharpen the teeth (1) uniformly –
N
do not alter the contour of the parent
blade (2) in any way.
See cutting attachment packaging for
additional sharpening instructions. Keep
the packaging for future reference.
English
1
2
1
2
31