Silvercrest SMZC 500 C2 Operating Instructions Manual page 60

6) Place the motor unit 3 onto the lid 5 so that the logo is facing it . The two
catches e on the inner ring of the lid 5 now engage into the two recesses r
on the bottom of the motor unit 3 . If the catches e do not slide immediately
into the recesses r on the bottom of the motor unit 3, turn the motor unit 3
a little until it rests flush on the lid 5 and the catches e have slid into the
recesses r .
7) Insert the plug into a mains power socket .
NOTE
► Hold the bowl 9 firmly with one hand and the motor unit 3 with the other
hand while processing food .
8) Press the required speed button 1/2 . The blade rotates 8 as long as
you keep the speed button 1/2 pressed . The motor stops as soon as it is
released .
CAUTION – PROPERTY DAMAGE!
► If the blade 8 stops and starts or does not turn at all, release of the speed
button 1/2 immediately and pull out the mains plug . Check whether
the blade 8 is jammed as a result of too hard/tough food and free this .
Otherwise, the motor unit could overheat .
NOTE
► If food remains stuck on the inside of the bowl 9 and the blade 8 cannot
reach it any more, open the lid 5 and push the food back down with a
spatula or similar .
9) Once the food is fully chopped, release of the speed button 1/2 .
10) Remove the power plug from the socket .
WARNING – RISK OF INJURY!
► Never attempt to remove food from the bowl 9 while the blade 8 is still
turning . There is a risk of injury and food can also spray out and make a
mess .
11) Wait until the blade 8 has come to a complete standstill .
12) Lift the motor unit 3 off the lid 5 .
13) Remove the lid 5 .
SMZC 500 C2 57 ■
GB│MT │