Feed Dog Height - ELNA 1000 Sew 75 Service Manual

FEED DOG HEIGHT

To check:
1. Lower the presser foot.
2. Turn the handwheel toward you to bring the feed dog to its highest position. The height of the feed
dog from the needle plate should be 0.75-0.90mm.
If it is not in the range, adjust as follows.
Adjustment procedure:
1. Open the shuttle cover.
2. Lower the presser foot and turn the handwheel toward you until the feed dog comes to its highest
point.
3. Loosen the setscrew (A) .
4. Turn the feed lifting pin to adjust the height of feed dog (0.75-0.90 mm).
5. Tighten the setscrew (A).
6. Turn the handwheel toward you to recheck the height of feed dog.
Needle plate
MECHANICAL ADJUSTMENT
0.75-0.90 mm
Feed lifting pin
15