Husqvarna 525BX Workshop Manual page 26

Repair instructions
Lubricate the spindle with a little grease and fit the
starter pulley. Tighten the screw.
Assemble a new starter cord. Slide it into the
starter pulley's slot as illustrated and then out
through the cord guide in the starter housing.
Make sure the knot on the end of the cord is as
small as possible!
NOTE!
A new starter cord can be fitted without
the need of dismantling the starter!
Assemble the starter handle.
Tie a double knot and fold under the free end.
Pull the knot fully into the handle.
Tension the return spring.
Pull the starter cord out completely and slow the
starter pulley with your thumb.
Lift the cord into the notch on the starter pulley.
Now turn the starter pulley clockwise, 6 turns.
Check the spring tension. With the starter cord
fully extended it should still be possible to turn the
starter pulley further, at least a half turn.
26
- English