Husqvarna 525BX Workshop Manual page 45

NOTE!
Slowly turn the fly wheel anticlockwise,
and after applying the stopper (special
tool) lightly to the piston head, loosen
the nut. The piston head can be dama-
ged if too much force is applied when
loosening the nut.
Take out the flywheel nut (A).
Fly wheel nut width across flats (WAF) M8 (WAF
12 mm)
Using the puller, 587 74 22-01, remove the fly
wheel from the crankshaft.
Removal bolt size M5 (hex socket WAF4).
NOTE!
Screw the removal bolt into the fly wheel
until the thread is at least halfway in.
Fig 4
A Puller assembly
B Puller bolt
C Fly wheel
D Removal bolt
Repair instructions
A
B
C
D
45
English -