Digi AnywhereUSB Plus Series User Manual page 15

Get started
Item Name
1 DB9 Console
2 USB port LEDs
3 ETH 1/2
4 SFP+ 1/2
5 Fan1
5 Fan2
5 User
5 PSU1
5 PSU2
5 Wi-Fi Service
5 WWAN1 Service
5 WWAN1 Signal
6 BT
AnywhereUSB® Plus User Guide
Description
Used to access a console using the RS232 DTE interface.
The USB ports support 1.1, 2.0, and 3.1 USB devices.
The LED illuminates as follows, based on the speed of the USB
device:
1.1 (Full speed): Yellow
n
2.0 (High speed): Green
n
3.1 (Super speed): Blue
n
Connect a Cat 7 STP Ethernet cable. The second Ethernet cable is
optional and used for redundancy.
Note Digi recommends that you use either the Ethernet cable or
the SFP+ module. If both the Ethernet cable and the SFP+ module
are connected, the SFP+ module will have priority.
Connect an SFP transceiver module for fiber connection, such as
Finisar Network FTLX8574D3BCL SFP+. The second SFP+ module is
optional and used for redundancy.
The LED shows the status of Fan 1:
Solid green when the fan is running within normal range of
n
use.
Solid red if the fan slows down or the Hub is overheating.
n
The LED shows the status of Fan 2:
Solid green when the fan is running within normal range of
n
use.
Solid red if the fan slows down or the Hub is overheating.
n
LED used for the Find Me feature. When this feature is activated,
the LED blinks orange and then green. You can configure the
Me feature in the web UI or by using the
The LED is blue when the Hub is powered, and solid red if the Hub
is not powered or the supply has failed.
The LED is blue when the Hub is powered, and solid red if the Hub
is not powered or the supply has failed.
Reserved for future use.
Reserved for future use.
Reserved for future use.
Reserved for future use.
Verify product components
Find
findme CL command.
15