Table of Contents
Advertisement
Chapter 4: UEFI BIOS
Ipv6 HTTP Support
Select Enabled to enable Ipv6 HTTP boot support. If this feature is disabled, it will not create
the Ipv6 HTTP boot option. The options are Enabled and Disabled.
IPSEC Certificate
Select Enable to enable the IPSEC certificate for Ikev support. The options are Disabled and
Enabled.
PXE boot wait time
Use this feature to select the wait time to press the <ESC> key to abort the PXE boot. The
default is 0.
Media detect count
Use this feature to select the wait time in seconds for the BIOS ROM to detect the LAN media
(Internet connection or LAN port). The default is 1.
Super IO Configuration
Super IO Chip AST2500
Serial Port 2 Configuration
Serial Port
Select Enabled to enable Serial Port 2. The options are Enabled and Disabled.
Device Settings (Available when the item above "Serial Port" is set to Enabled)
This feature displays the base I/O port address and the Interrupt Request address of a serial
port specified by the user.
Change Settings
This feature specifies the base I/O port address and the Interrupt Request address of Serial
Port 2. Select Auto for the BIOS to automatically assign the base I/O and IRQ address to a
serial port specified.
The options for Serial Port 2 are Auto, (IO=2F8h; IRQ=3), (IO=3F8h; IRQ=3, 4, 5, 6, 7, 9,
10, 11, 12), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12); (IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10,
11, 12), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12).
Serial Port 2 Attribute
Select SOL to use COM Port 2 as a Serial_Over_LAN (SOL) port for console redirection.
The options are COM and SOL.
101
Hide quick links:
Advertisement
Table of Contents
