Caution For Handling The Unit With Built-In Hdd - Sony BKNW-116 Installation Manual

Caution for Handling the Unit with Built-in HDD

This unit has built-in hard disk drives (HDDs). Pay careful attention to the following and operate with
care when installing and servicing this unit.
Never give any mechanical shock and vibration.
This may cause an HDD trouble or destroy the data in HDD.
. Pack this unit using specified packing materials when carrying the unit. Use a cart with less-vibration
when carrying this unit by a cart. If an excessive mechanical shock and vibration are applied, the HDD
may be damaged.
. Never move this unit under the power-on state. Take out or insert this unit from/to the rack under the
power-off state. Also never install or remove the cabinet under the power-on state.
. When this unit is in a vehicle, never turn on the power during running.
. When putting the unit on the floor, put this unit gently with the four specified feet which is attached to
the bottom of the unit on the floor. If there are no feet on the bottom, attach them before putting this
unit, or put this unit gently so that no sound is generated.
Never operate the unit for 30 seconds after the power is turned off.
The disks in HDD rotate by inertia for a while after the power is turned off. In this case, the heads are in
the unstable state. During this period, the HDD is more sensitive to a mechanical shock and vibration
than during power-on state. Never give even a slight shock at least 30 seconds after the power is turned
off. Operations can be initiated (because the disks stop) after 30 seconds or more.
In the event of trouble in HDD
If there is something wrong with the HDD of this unit (a failure occurs in the HDD), handle this unit in
the same manner as described above. This protects the HDD from increace of the damage till confirming
the contents of the failure or analyzing the failure.
BKNW-116
3 (E)