Rack Mounting - Sony BKNW-116 Installation Manual

Disk unit
Hide thumbs Also See for BKNW-116:
Table of Contents

Advertisement

1-6. Rack Mounting

1-6. Rack Mounting
This section explains how to mount this unit in a 19-inch
standard rack.
Install this unit in a rack accurately as following procedure
with the specified rack mount rail.
If not, there is a fear of unexpected accident such as a drop
of the unit or turnover of the rack.
c
. Use the specified rack mount rail.
If not, it may cause of injury by drop of the unit because
strength of rail is not enough.
. To prevent turning over the rack, fix the rack on the
horizontal and firm floor securely with bolts, etc.
. Pay careful attention not to catch the power cord in the
rack mount rails.
m
. When other equipment with built-in hard disk drive is
already installed in the rack, turn off the power of the
equipment before mounting this unit in the rack.
. Never remove the upper lid, bottom plate, and so on
during rack mounting.
. Adjust so that the temperature inside of the rack is in the
range of the unit's operating temperature.
. Connect the hybrid recorder after mounting this unit in
the rack.
Specified Rack Mount Kit
RMM-130 (Option)
Parts packed in RMM-130
. Slide rails
. Rack angles (handles)
. Rail brackets
. Plate nuts (large)
. Plate nuts (small)
. Screws (PSW4 x 16)
. Screws (B4 x 8)
. Hexagon socket head cap screws
. Flat washers
. Screws (RK5 x 14)
. Ornamental washers
. L-shaped hexagon wrench
1-4 (E)
Rack Mounting Procedures
1. Removal of feet
n
When placing this unit, take care not to give a shock to this
unit. Pay particular attention to move this unit without feet.
(1) Place the unit on its side panel down.
(2) Unscrew the four screws and remove the feet from the
(3) Replace the unit to the horizontal position.
n
Keep these screws and feet which are removed in this
procedure carefully.
When the unit is used without rack mounting, it is required
2
to attach these feet.
2
If the unit is placed without four feet, the hard disk drive
4
may break down by mechanical vibration, shock, etc.
4
Tightening torque: 98 x 10
4
4
8
8
8
2
2
1
bottom plate of the unit.
Foot
PS4 x 14
Foot
PS4 x 14
-2
N.m{10 kgf.cm}
Foot
PS4 x 14
Foot
PS4 x 14
BKNW-116

Advertisement

Table of Contents
loading

Table of Contents