2. Attachment of inner rails
(1) Pull out each inner rail from the two intermediate rails.
(2) While pressing the stopper of the inner rail in the
direction of the arrow A, pull out it in the direction of
the arrow B in the figure. (Pull out the other inner rail
in the same way.)
Intermediate rail
Inner rail
Stopper
B
(3) Remove the ten screws shown in the figure from both
sides (left and right) of the unit.
B4 x 6
(4) Attach the two inner rails to both sides (left and right)
of the unit with eight screws of ten removed in the step
(3).
Tightening torque: 120 x 10
Inner rail
B4 x 6
BKNW-116
Outer rail
A
B4 x 6
-2
N.m{12.2 kgf.cm}
Inner rail
B4 x 6
3. Attachment of rack angles (handles)
(1) Remove the four screws shown in the figure from both
sides (left and right) of the unit.
B4 x 6
n
Keep these screws (B4 x 6) that are removed in this
step (1) carefully. In case of directly attaching the side
panels after removing the rack angle, it is required to
use these screws.
(2) Attach the two rack angles to the unit with four screws
(PSW4 x 16) .
Tightening torque: 120 x 10
PSW4 x 16
Rack angle
Rack angle
1-6. Rack Mounting
B4 x 6
-2
N.m{12.2 kgf.cm}
PSW4 x 16
1-5 (E)