The manufacturer, following a policy of constant development and up-dating of
the product, may make modiﬁcations without giving prior notice.
BEFORE CALLING FOR SERVICE
Drain pump doesn't
Suds in the tub
Stained tub interior
Dishes are not dried
Dishes and ﬂatware
Fuse blown or the circuit
Power supply is not turned
Water pressure is low.
Some audible sounds are
Utensils are not secure in
the baskets or something
small has dropped into the
Spilled rinse agent.
Detergent with colorant
Rinse agent dispenser is
Improper rack loading.
WHAT TO DO
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Check that the water supply is connected
properly and the water is turned on.
The system is designed to detect an
overﬂow. When it does, it shuts off the
circulation pump and turns on the drain
Sound from soft food shredding action
and detergent cup opening.
To ensure everything is secured in the
Dishwasher has not been used regularly.
If you do not use it often, remember to
set it to ﬁll and pump out every week,
which will help keep the seal moist.
Use only the special dishwasher
detergent to avoid suds.
If this occurs, open the dishwasher and
let suds evaporate.
Add 1 gallon of cold water to the tub.
Close and latch the dishwasher, then
start the Pre Wash cycle to drain out the
water. Repeat if necessary.
Always wipe up rinse agent spills
Make sure that the detergent is the one
Make sure that the rinse agent dispense
Select a more intensive wash program.
Make sure that the action of the detergent
dispenser and spray arms are not
blocked by large dishware.