A&D FC-50Ki Instruction Manual page 39

f-05-03 f-05-03 f-05-03 f-05-03
f-05-04 f-05-04
f-05-04 f-05-04
f-05-05 f-05-05 f-05-05 f-05-05
f-05-06 f-05-06 f-05-06 f-05-06
F-06-X/F-07-X/F-08-X Data Output F-06-X/F-07-X/F-08-X Data Output
F-06-X/F-07-X/F-08-X Data Output F-06-X/F-07-X/F-08-X Data Output
f-06-X for standard RS-232C,
f-07-X for Ch.1 (PORT 1) and
f-08-X for Ch.2 (PORT 2).
06 06 06 06
f- X -01
f- f- f- -01 -01 -01
07 07 07 07
08 08
08 08
q Upper Limit.
Enter via the 10-key pad.
0 0 0 0
!
Use the - or
q Lower Limit.
Enter via the 10-key pad.
0 0 0 0
!
Use the - or
q A Beeper With Comparator Results.
These are beeps for the comparator, not for the key
operation.
000 000
000 000
! All Comparator Beepers are OFF.
000 000 000 000
0 0 0 0
= Beeper OFF
1 1 1 1
HI LO
= Beeper ON
OK
q Factory Use.
0 0 0 0
! This setting should be "0".
q Data Out Mode
Key mode: Data is sent by pressing the PRINT key.
0 0 0 0
!
+ command mode.
Stream mode: Data is sent continuously.
1 1 1 1
command mode cannot be used.
Auto-print mode A: Data is sent if the weight display is stable
2 2 2 2
at +5d (weighing display division) and above.
+ command mode.
Auto-print mode B: Data is sent if the weight display is stable,
3 3 3 3
at ±5d (weighing display division) and above/below.
+ command mode
4 4 4 4
Command mode only.
. key to "set minus value.
. key to set minus value.
Example:
The OK beep sounds – HI & LO doesn't
sound. The scale will beep continuously
when display meets OK condition.
37
010 010
010 010