Setting The Input Channel; Setting The Picture-To-Sound Carrier Spacing - Triax CCT 391 Assembly Instructions Manual

Setting the input channel

Bx 1A INPUT:
C12
• Use
Setting the fine-tuning
• If necessary press down
pears in the display.
• Use the
(63 ... -64).
• Press
• Press the
—> The "Setting the picture-to-sound carrier spacing" –

Setting the picture-to-sound carrier spacing

If the picture are distorted (moire 1.07 MHz), you may cut the
two sound carriers by ca. 3 dB.
Bx 1A PICT-SOUND
Pic/Snd normal
M
• Use the
to-sound carrier spacing ("normal" ... "-3 dB").
Bx 1A
C12
to set the input channel.
buttons to fine-tune the output channel
to return to the channel setting.
◀
button.
"PICT-SOUND" menu is activated.
normal ... -3 dB
buttons to change the setting of the picture-
- 13 - - 13 -
INPUT:
63 ... -64
Fine 0
until "Fine 0" also ap-
▶
A