Control Knobs - Weber SKYLINE 520 Owner's Manual

Lp gas barbecue

Hide thumbs Also See for SKYLINE 520:

Table of Contents

Enlarged version

Step 19

Install Lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the

barbecue. Insert hinge pins from the outside. Insert hair pin

cotters into the small holes in the hinge pins. Figure 25.

Figure 25

Hair pin cotter

Hinge pin

Step 20

Add tool holders, control panel and burner

control knobs

You will need: two tool holders, control panel, two Phillips

screws/washers, a Phillips screwdriver, and two burner

control knobs.

Hook the tool holders over the frame rail. Figure 26.

Set the control panel in place over both frame braces.

(Hold the Crossover Ignition button up while setting the

control panel in place.) Line up the holes in the control

panel with the holes in the inserts in the frame brace.

Insert screws and tighten with a Phillips screwdriver until

snug. Do not overtighten.Figure 26 (a).

Push on the burner control knobs. Figure 26 (b).

Crossover

Ignition

Button

Tool holders

Insert in

frame brace

(a)

Control panel

Phillips screws/

washers

(b)

Figure 26

Table of Contents