E) Adjusting The Operating Mode And Parameters In The Program Menu - VOLTCRAFT V-CHARGE 600 DUO Operating Instructions Manual

Cut-off temperature
Lighting
Volume
Servo pulse signal
Servo pulse levels
System information
Factory default settings
Back

e) Adjusting the operating mode and parameters in the program menu

• After establishing the power supply, the LC display (9) switches to the home/standby display.
• Turn the rotary switch 1 (10) for the charging channel, to select a menu item and to scroll up or down. The values
are displayed on the LC display.
• Confirm the setting by briefly pressing the rotary switch.
The cell voltage as well as the cell resistance can only be displayed when balancer charging is used.
• Press the rotary switch for a charging channel. The program menu for the parameter setting appears on the LC
display.
The following menu items are available for selection:
Battery type
Number of cells
Mode
Current
Cell voltage
Start
Back
The charger terminates the charging process if the battery temperature reaches the
maximum cut-off value. An external temperature sensor is required for this feature
to work.
The brightness of the backlight of the LC display can be adjusted in three stages.
The options available are: Off > Low > Medium > High.
The volume of the charger can be adjusted. The options available are: Off > Low >
Medium > High. If 'Off' is selected, warning tones are not suppressed and continue
to sound.
Change the pulse width modulation (PWM) for the servo motor to be able to test the
positioning (adjustment angle) of the servo arm.
You can change the speed of a brushless motor. You can adjust the pulse width.
This menu item allows you to view the firmware version and other system informa-
tion.
Restore factory default settings.
Return to the last program or menu.
Select a battery type.
Set the number of cells in the battery pack.
Set the operating mode. Charge/Discharge/Storage/EXT.DISC are available for selection.
Select the required charging current between 0.1 and 16 A, the discharging current 0.1 to
3 A, as well as the additional discharging current of 0.1 to 15 A.
Setting of the charging voltage at the connections.
Start an operation in the set operating mode (charging, discharging, storage, etc.).
Return to the previous display or function.
27