Quickie Life RT Directions For Use Manual page 22

Footboard
Footrest - Aluminium
There are several footboards available.
These can be flipped up to make it easier to transfer to/from the
chair.
Lower leg length (Fig. 6.10)
By undoing the clamp screw (1), you can adjust the lower leg
length. Loosen the clamp screw, adjust the tube on the
footboard to the desired position.
Tighten clamp screws again (see the page on torque). Ensure
that the plastic push joint is located under the clamp screw in
the correct position.
The screws used are fitted with threadlock at the factory and
can be adjusted up to 5 times after fitting. After that they should
be replaced or alternatively re-secured with threadlock to
medium tightness.
Footrest - Aluminium
There are several footboards available.
These can be flipped up to make it easier to transfer to/from the
chair.
Fig. 6.10
1
22
Angle-Adjustable Footboard
The footboard can be flipped up to make it easier to transfer to
and from the chair, (Fig. 6.11 - 6.12.1).
This can be adjusted to alter the angle to the ground.
Tighten screw (1) on the outside. By loosening the clips (2) the
footboard can be moved to three positions both forwards and
backwards. By adjusting the set screw (3) the footboard can be
changed to a horizontal position. To do this, the footboard must
be flipped up. Make sure that after any adjustment work, all
screws are tightened correctly (see the page on torque). Ensure
that you maintain the minimum gap to the floor (2.5 cm).
Fig. 6.11
1
Fig. 6.12.1
3
Footrest - Plastic
Footplates:
The footplates can be flipped up to make it easier to transfer to/
from the chair.
Lower Leg Length:
For users with longer legs, the leg support can be lowered to
the appropriate level by using the screws. Loosen the screws,
push the tubes to the desired position and then re-tighten the
screws (see section on torque).
There must always be a minimum gap of 2.5 cm between the
footplates and the ground. (Fig. 6.13)
Fig. 6.12
2
Fig. 6.13
>2.5 cm
Life RT Rev.2.5