Siemens SIMATIC S7-1500 Function Manual page 62

Procedure
Proceed as follows to configure the system diagnostics:
1. Double-click the "System diagnostics view" object in the "Tools" task card. The object is
added to the screen.
Figure 4-28
2. Select the "Properties" tab in the Inspector window.
3. Select the area "Columns".
4. Enable the columns that you require in the device view for WinCC Runtime, for example:
– Status
– Name
– Operating mode
– Slot
– Address
5. Enable the columns that you require in the detail view for WinCC Runtime, for example:
– Status
– Name
– Operating mode
– Plant designation
– Address
6. You can change the column headers in the "Columns" area, if necessary.
7. Select the "Display" area.
8. Enable "Column settings > Columns moveable" to move the columns in WinCC Runtime.
9. To close the system diagnostics window in WinCC Runtime, select "Properties > Window
> Closable" in the "Properties" tab of the Inspector window.
Diagnostics
Function Manual, 11/2019, A5E03735838-AF
Adding a system diagnostics view
Setting and determining system diagnostics
4.2 Options for displaying system diagnostics
61