Table of Contents
Advertisement
Band Controls
T
he Band Controls section features controls over the Crossover network which splits the input into
Frequency Bands. Each Band has controls for Solo, Gain, Priority, Release, and a Mete
in
put level.
Se
pa ation
r
- R
an e 0 to 100
g
- Defau
lt 100
Separation is similar to a filter cutoff slope (or Q) between the bands' sidechain being fed to the
PLMixer™. At low Separation settings, crossover slopes between bands are moderate, creating more
overlap between the bands. At higher Separation settings, the crossover slopes are steeper, resultin
in
less overlap between the bands.
Crossove
r (Xover) Controls
Just below t
he graph are the Crossover frequency adjustment controls. There are 4 Crossovers in the
L3-LL. Eac
h s ts the cutoff frequencies for the corresponding High Pass and Low Pass filters.
e
Each of the
four Crossovers has a unique range of frequencies, as follows:
LOW Range:
20Hz to 350Hz. Default to 80Hz.
L
O
W
MID Range: 150Hz to 300Hz. Default to 320Hz.
H
I MID Range: 1000Hz to 5000Hz. Default to 1278Hz.
H
I Range: 3kHz to 11kHz. Default to 5113Hz.
P
er Band Solo
Solo the frequency band to adjust the frequency bandwidth. Solo outputs the signal post the crossovers
and pre the dynamic process.
L3-LL User Manual
r displaying the
g
15
Advertisement
Table of Contents
