HWH 200 Series Operator's Manual page 7

CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
IMPORTANT: Extending or retracting any leveling
jacks when the room is extended is not recommended.
1. Insert the KEY and turn the KEY SWITCH on the ROOM
OPERATOR'S PANEL to the "ON" position.
2. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted.
NOTE: Hold the switch to "RETRACT" three or four seconds
after the room is fully retracted. This assures proper
pressurization of the cylinders.
of the room, do not reverse direction of the room until
the room is fully retracted. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT retract the room until the room
has been fully extended.
OPERATING PROCEDURES
ROOM RETRACT PROCEDURE
During normal operation
IMPORTANT: Do not hold the ROOM CONTROL SWITCH
in the "RETRACT" position for more than ten seconds
after the room is fully retracted or stops moving.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
NOTE: Releasing the ROOM CONTROL SWITCH will
halt the operation of the room.
3. Turn the KEY SWITCH on the ROOM OPERATOR'S
PANEL to the "OFF" position.
4. Remove the KEY to prevent undesired
operation of the room.
5. Engage all room locking devices.
6. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
IMPORTANT: Room-locking devices should be locked
while traveling.
MP35.553C
08DEC03