HWH 200 Series Operator's Manual page 6

CAUTION:
OPERATING THE ROOM WITH ANY
ROOM-LOCKING DEVICES LOCKED OR THE MANUAL-
RETRACT WINCH ATTACHED CAN CAUSE PERSONAL
INJURY AND VEHICLE DAMAGE. IT IS THE OPERATOR'S
RESPONSIBILITY TO ENSURE THAT ALL ROOM-LOCKING
DEVICES AND THE MANUAL-RETRACT WINCH ARE
DISENGAGED BEFORE OPERATING THE ROOM.
IMPORTANT: It is recommended to level and stabilize
the vehicle before extending the room.
IMPORTANT: Extending or retracting any leveling jacks
when the room is extended is not recommended.
1. Follow the LEVELING AND STABILIZING PROCEDURE.
2. Unlock all room-locking devices.
NOTE: If the MANUAL RETRACT WINCH is attached to
the room remove it before extending the room.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
NOTE: Make sure there is adequate clearance
to fully extend the room.
3. Turn the ignition switch to ACCESSORY.
4. Press the "ON" button on the leveling system control
panel if the POWER ON LIGHT is not illuminated.
5. Insert the KEY and turn the KEY SWITCH to
the "ON" position.
OPERATING PROCEDURES
ROOM EXTEND PROCEDURE
6. To extend the room, press and hold the ROOM
CONTROL SWITCH in the "EXTEND" position
until the room is fully extended.
NOTE: Hold the switch to "EXTEND" three or four seconds
after the room is fully extended. This assures proper
pressurization of the cylinders.
of the room, do not reverse direction of the room until
the room is fully extended. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT re-extend the room until the room
has been fully retracted.
IMPORTANT: Do not hold the ROOM CONTROL SWITCH
in the "EXTEND" position for more than ten seconds
after the room is fully extended or stops moving.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
NOTE: Releasing the ROOM CONTROL SWITCH will halt
the operation of the room.
7. Turn the KEY SWITCH to the "OFF" position and remove
the key to prevent undesired operation of the room.
8. Press the "OFF" button on the leveling system
control panel.
9. Turn off the ignition switch.
IMPORTANT: Do not use the room extension support
when the vehicle is supported by the leveling system.
During normal operation
MP35.551
08DEC03