HWH 200 Series Operator's Manual page 25

BREATHER CAP - DIPSTICK - 1/4" NUT DRIVER
VALVE RELEASE
NUT
VALVE RELEASE
NUT
PLASTIC PLUG
REMOVE TO
GAIN ACCESS
TO THE 1/4"
VALVE RELEASE
NUT
EITHER TO CHECK THE OIL LEVEL OR TO USE THE 1/4" NUT DRIVER,
BEFORE RETURNING THE BREATHER CAP TO THE RESERVOIR,
REMOVE ANY PAINT CHIPS OR OTHER DEBRIS FROM THE DIPSTICK
NOTE: DO NOT turn the valve
release nut more than 2 full
turns counter clockwise. Damage
to the valve may result.
NOTE: THE BREATHER CAP IS LOCATED
ON THE TOP SIDE OF THE POWER UNIT RESERVOIR.
OIL LEVEL
IMPORTANT: PRIOR TO REMOVING THE BREATHER CAP,
CLEAN ANY DEBRIS FROM THE TOP OF THE RESERVOIR.
INCLUDING DEBRIS INSIDE THE 1/4" NUT DRIVER.
NOTE: DO NOT turn the valve
release nut more than 4 and 1/2
(four and one half) turns counter
clockwise. Damage to the valve
may result.
1/4" NUT DRIVER
OIL LEVEL GROOVES
BREATHER CAP
1 1/2" DIAMETER
SOLENOID VALVE
2 1/4" DIAMETER
SOLENOID VALVE
MP85.999X
20JAN10