Table of Contents
Advertisement
LAN unit
Your computer is equipped with a 100 Base-TX/10 Base-T LAN interface. To
activate the LAN adapter, perform the following steps.
1.
Turn off the computer.
2.
Remove the cover of the LAN jack on the left side of your computer. Connect
one end of the LAN cable into the LAN jack.
3.
Connect the other end of the LAN cable into the network hub.
5
Network Hub
4.
Turn on the computer.
5.
From the Start menu, select Settings-Control Panel.
6.
Double-click System icon.
7.
Click Device Manager tab.
8.
Double-click Network adapters.
9.
Double-click Realtek RTL8139xxxx.
10. Click General tab and uncheck Disable in this hardware profile.
11. Click OK; then Close.
12. In the Network dialog box, set fields according to your network status. Refer to
your network administrator.
You cannot use the LAN unit when the computer is in MS-DOS mode.
5-6
LAN Jack
Advertisement
Table of Contents
