Sharp PC-AX Series Manual page 32

Removing Optional External CD-ROM Drive
1. Remove the CD from the CD-ROM disk drive.
2. Turn off the computer.
3. Disconnect the CD-ROM disk drive unit by pulling out the connector.
2
Handling CDs
•
Do not write on either side of the disc, particularly the non-label side. Data is
read from the non-label side. Do not mark this surface.
•
Keep your discs away from direct sunlight, heat and excessive moisture.
•
Always hold the CDs by the edges. Fingerprints, dirt or water on the CDs can
cause noise or mistracking. If a CD is dirty or does not play properly, clean it
with a soft, dry cloth, wiping straight out from the center, along the radius.
Inserting a CD
You can operate the CD-ROM drive only when the computer is on.
1. Make sure the CD-ROM drive indicator does not light on (it is supposed to
blink periodically).
2. Press the eject button to open the CD tray slightly.
3. Gently pull out the tray.
Indicator
2-12