Honeywell OneWireless XYR 6000 User Manual page 39

To connect your transmitter to the OneWireless network perform the following steps.
Step
1
If the Provisioning Device contains no keys, obtain new security keys from
the Wireless System Gateway user interface.
2
When the Provisioning Device has valid unexpired keys, aim it at the
transmitter and transmit a key to the transmitter. The transmitter will validate
the key and then use it to make a connection to the OneWireless network.
The Transmitter may continue to show the diagnostic message "NO KEY" for
a brief time while it validates the key before showing the "DISCOVER"
message.
To verify your transmitter has been provisioned, see the Connection prompt
on the Read Device Information screen (page 31).
To deprovision your transmitter from the OneWireless network, select Reset Device to Defaults. This
clears the transmitter's key, network and security configurations, and resets the transmitter to its factory
default settings. perform the following steps.
Select Provisioning Data (under Advanced Options) when:

The Provisioning Device has keys from one system, but you are using provision device on another
system, or

you want to clear all keys so that you cannot deploy any more keys without going to the Wireless
System Gateway user interface and getting more.
For more details on keys, refer to Getting Started with Honeywell OneWireless Solutions.
Revision 3 OneWireless XYR 6000 ISA100.11a Compliant Pressure Transmitter User's Manual
March 2012
Action
5. Operation
5.6. Provisioning Device menus
29