Valor HORIZON 613CCB Installation Instructions Manual page 4

4. Fix the hanging brackets to the back side of
the Inner Casting as shown. Note the left/right
orientation of the brackets.
5. There are 4 tabs on the inside of the heater's black
frame; those are intended for mounting other trims.
These tabs confl ict with the installation of the cast
front packaged with this kit. These 4 tabs must
either be cut off or bent back out of the way to allow
the Inner Casting to install —see diagram.
6. Hook the Inner Casting to the edge of the backing
plate fl anges as shown.
4
7. Drop cast iron fret into place by sliding the bolts into
the slots of the fret brackets on the inner casting.
Adjust bolts as necessary for a tight fi t.
8. Hook the ash pan to the fret.
9. Adjust top heat baffl e by pulling it forward until it
lines up with the fl ange of the top part of the backing
plate. Tighten the screws.
Section View of
the 613CCB Kit--
Right Side View
Backing Plate Top
Backing Plate Flange
Heat duct must be
adjusted to be flush
with protuding flange
of backing plate
Backing Plate Left Side
Inner Casting
Front of fireplace
10. Install the barrier screen. Insert the top clips inside
the top of the inner casting. Push the bottom against
the cast front so the clips snap into place on top of
the fret.
top
bottom
front view
Drywall
68 mm long 31-1/4"
Flange from floor
Black Frame
534 Engine
space between
the edge of screen
and hook is smaller
at the top than at
the bottom (top and
bottom hooks are
also different)