D Ceram C0 Data Sheet; General Information; Description; Composition - Wilo EMU FA+HC20.1 Series Installation And Operating Instructions Manual

D Ceram C0 data sheet
WILO products are used for many different pumped liquids and installation sites. We want our coat-
ings to offer an even higher degree of protection against wear and corrosion. For this purpose, we
mainly use our Ceram coatings. However, only an intact coating provides the best possible protec-
tion.
Therefore check the coating after all installation and maintenance work, and repair any minor dam-
age immediately. In the event of major damage, please consult the manufacturer.
Ceram C0 is a sprayable, solvent-free, two-component aluminum-oxide-based coating material
which protects our products from corrosion under particularly harsh mechanical conditions.
Solvent-free epoxy polymer with solvent-free polyamine hardener and various extenders.
- A tough, hard and long-lasting coating with high mechanical and chemical resistance and
excellent resistance to abrasion.
- Excellent wet adhesion and compatibility with corrosion protection as a single-layer coating
on steel surfaces.
- Very good adhesion to steel surfaces.
- Replaces coatings containing tar.
- Cost-effective thanks to its durability, low maintenance and easiness to repair.
- Tested by the Federal Waterways Engineering and Research Institute (BAW).
- Solvent-free.
- High-gloss coating when hardened.
Density (mixture)
Adhesion / steel
Impact resistance / hardness
Temperature resistance: dry, long-
term
Temperature resistance: dry, short-
term
Temperature resistance: wet / fluid
Solid content (mixture)
Table D-1: Technical data
E:\shares\Baprod\BA\subtec_m\appendix\us\general\c0.fm
ASTM D 792 1.4
ISO 4624 15
DIN EN ISO
9
6272
60
120
Depends on Information on
pumped fluid request
Volume 97
Weight 98
Ceram C0 data sheet

General information

Description

Composition

Properties

Technical data

3
g/cm
2
N/mm
J
°C
°C
°C
%
%
D-1