Power Connection; Raven Receivers; Non-Raven Receivers; Routing Gps Signal - Raven TM-1 Installation And Reference Manual

Chapter 2

Power Connection

Note:
The TM-1 draws approximately 150 mA (peak) of current at +12 V DC. During normal operation, it
draws much less.

Raven Receivers

When used with a Raven DGPS receiver, power for the TM-1 may be supplied using the DB-9 serial port
connectors. Refer to the following table for compatible receivers or other options for powering the TM-1 with a
Raven DGPS receiver:

Non-Raven Receivers

For non-Raven receivers, the 4-Pin power cable (P/N 420-1001-701) is required to provide power to the TM-1
Tilt Module. Connect:
the red power lead to a clean source of switched +12 V DC.
1.
the black power lead directly to battery ground.
2.
Note:
The green and white wires are not used.

Routing GPS Signal

In order for the TM-1 Tilt Module to provide a corrected GPS position for guidance and location, route a raw or
uncorrected GPS signal from the DGPS receiver to the 'GPS IN' port on the TM-1.
Note:
The TM-1 intercepts the GGA message strings from the receiver, corrects for the measured
machine tilt and then transmits a corrected signal with minimal delay. All unrecognized serial input
and messages are passed through unmodified.
4
Raven DGPS Receiver
Phoenix 10 (speed only)
Phoenix 50
100S
100G
Invicta 115 (obsolete)
Invicta 210
Invicta 310
RPR 400C (obsolete)
RPR 410 (obsolete)
Phoenix 200
Phoenix 250
Phoenix 300
GPS from Cruizer or
Cruizer II
GPS from Envizio Pro or
Envizio Pro II
Power TM-1 Through Port:
n/a
A
A
A
A
A or B
A or B
A or B
A or B
A
A
A or B
Use the GPS Out port on the tilt
interface cable (P/N 115-0171-794)
Use the supplied 4-Pin power cable
(P/N 420-1001-701)
TM-1 Tilt Module Installation & Reference Manual