Install The Accuboom Harness Cable; Install The Power Connection; Install The Can Connections - Raven AccuBoom 117-1001-076 Installation Manual

C 3
HAPTER

INSTALL THE ACCUBOOM HARNESS CABLE

INSTALL THE POWER CONNECTION

FIGURE 2. AccuBoom Harness Power Connection
1. Locate the 4-pin weather pack connector in the node enclosure.
2. Remove the dust cap from the weatherpack connector.
3. Connect the weatherpack connector to the power connection on the AccuBoom harness cable (P/N 115-1001-
037).

INSTALL THE CAN CONNECTIONS

FIGURE 3. AccuBoom CAN Connections
1. Locate the terminator in the node enclosure.
2. Remove the terminator from the machine's CAN connection.
NOTE: If the machine was previously equipped with the AutoBoom system, the CAN terminator may be
located on the AutoBoom harness.
3. Connect the machine's CAN connection to the AccuBoom harness CAN tee cable.
4. Connect the terminator to the other end of the AccuBoom harness CAN tee cable.
10 GVM Predator and Prowler AccuBoom Installation Manual