Ship Information Input; How To Install The Driver - Furuno FA-40 Operator's Manual

Ais receiver

Hide thumbs Also See for FA-40:

Table of Contents

SHIP INFORMATION INPUT

The FA-40 is set up from the PC or external display (TZTL12F*/15F* or TZT12F/16F/

19F). When setting from the PC, install the USB driver and PC software (see sections

2.1 and 2.2). When setting from the external display, open the home screen, and then

select [Settings] - [Initial Setup] - [NETWORK SENSOR SETUP] - [FA-40] in order to

display the menus.

*: The software version 07.01 or later is required.

2.1

The CD-ROM for PC software and USB driver is supplied as standard.

Note 1: Install the driver with administration rights.

Note 2: In the case of Microsoft

you need to re-install this file, install this file in [Device Manager].

Note 3: "Microsoft.NET Framework 4(×86 or ×64)" is installed at the time of the AIS

Setting Tool installation.

The following instructions are for Windows

1. Turn the FA-40 on.

2. Connect the USB cable between the FA-40 and the PC.

3. Set the supplied CD-ROM in the CD drive.

4. Click the [Start] button and then click [Control Panel].

5. Click [Device Manager].

6. Enter the administrator password and then click [Yes].

7. Double-click [Other devices] – [VIRTUAL COM PORT] in order.

8. Click the [General] tab and then click [Update Driver...].

9. Click [Browse my computer for driver software].

10. Select the [USBDriverForWindows7] folder in the CD-ROM.

11. Click [Install this driver software anyway] to install the driver. After the installation,

[FURUNO AIS (COMxx)] is displayed in [Ports (COM & LPT)] of [Device Manag-

er].

12. Remove the CD-ROM from the CD drive.

Windows

10, the "Driver" file is already installed. If

2-1

Table of Contents

Table of Contents