Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Important note: Radiation Exposure Statement
The product complies with the US portable radio frequency (RF)
exposure limit set forth for an uncontrolled environment and is
safe for intended operation as described in this manual. Further
RF exposure reduction can be achieved if the product is kept
as far as possible from the user's body or if the device is set to
lower output power if this function is available.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Country Code selection feature to be disabled for products
marketed to the US.
Need help?
Do you have a question about the Sleep Analyzer and is the answer not in the manual?
Questions and answers