Hot Plugging; Hot Plugging Kvm Ports; Port Selection; Manual Port Switching - ATEN CL6708MW User Manual

Single rail 8-port dvi fhd lcd kvm switch

Hide thumbs Also See for CL6708MW:

Table of Contents

Chapter 3. Basic Operation

Hot Plugging

The CL6708MW supports hot plugging – components can be removed and

added back into the installation by unplugging their cables from the ports

without the need to shut the unit down. In order for hot plugging to work

properly, the procedures described below must be followed:

In order for the OSD menus to correspond to KVM port changes, you must

manually reconfigure the OSD to reflect the new port information. See the F3

SET (page 32) and F4 ADM (page 34), functions for details.

Note: If the computer's operating system does not support hot plugging, this

function may not work properly.

The CL6708MW provides three port selection methods to access the

computers on the installation: Manual, OSD (on-screen display), and Hotkeys.

See Chapter 4, OSD Operation and Chapter 5, Keyboard Port Operation for

more information.

Use the Port LED/Port Pushbuttons located on the keyboard module to switch

KVM focus to any port on the installation.

Table of Contents