Preparation Before Use; Setting Up The Scanner - Canon imageFORMULA CR-135i II Instructions Manual

Preparation Before Use

This chapter describes how to prepare the scanner to scan
documents.

Setting Up the Scanner

Perform the following steps to set up the CR-135i II/CR-190i II. Refer to
the section for each step for details about that step.
A
Check your operating environment. (See "Checking Your
Operating Environment," on p. 18.)
B
Install the software. (See "Installing the Software," on
p. 19.)
Install the Scanning Utility provided with the CR-135i II/CR-190i II.
C
Connect the scanner to a computer. (See "Connecting
the Scanner to a Computer," on p. 20.)
D
Turn ON the power. (See "Turning ON the Power," on
p. 21.)
E
Automatically installing the device driver. (See p. 22.)
The device driver is installed automatically when Windows
recognizes the CR-135i II/CR-190i II.
IMPORTANT
• To have the device drivers installed automatically when the computer
recognizes the CR-135i II/CR-190i II, the software needs to be installed
before the CR-135i II/CR-190i II is connected to the computer.
• If you connect the computer and turn ON the CR-135i II/CR-190i II before
installing the software, the following wizard screen appears. If this
happens, click [Cancel], turn OFF the CR-135i II/CR-190i II, and then
install the software.
The following wizard screen is an example in Windows Vista. When a
similar wizard screen appears in Windows XP/7/8/8.1/10, click [Cancel].
Wizard Screen (Windows Vista)
17