Cleaning With The Cleaning Cards (United States Only) - Canon imageFORMULA CR-135i II Instructions Manual

Cleaning with the Cleaning Cards
(United States Only)
If a black stripe appears on the back-side of scanned images or if dirt
appears on the paper documents upon scanning or for preventative
measures, we recommend that you clean your Canon CR-Series
scanner as needed with a cleaning card. Using a cleaning card will
minimize the frequent cleaning as instructed in this manual.
It is best to perform a cleaning at beginning or end of the day. A cleaning card
does not clean the ink jet nozzles, so please remove the ink cartridge and
perform a nozzle cleaning (See "Cleaning the Ink Jet Nozzles," on p. 49.)
IMPORTANT
• This operation is for the Cleaning cards in the United States are
available only in the United States.
• Contact your local authorized Canon dealer or service representative
for the available cleaning card.
A
Turn OFF the scanner.
B
Disconnect the scanner and the computer.
C
Turn ON the scanner with pressing the START Button and the
STOP Button.
50
NOTE
If the scanner turned ON properly, the power LED continues to flash.
D
Press the Function Button to turn its LED off.
E
Pull the Eject Stopper.
F
Place the cleaning card in the document tray.
G
Press the START Button to start cleaning.
H
Please repeat steps 6 and 7.
A typical cleaning is feeding the cleaning card 3 to 7 times. If the
scanner is extremely dirty, you may need to use another cleaning
card.
I
Turn OFF the scanner.
J
Connect the scanner and the computer.
NOTE
Allow 1 to 2 minutes for the moisture on the Canon CR-Series scanner from
the cleaning card to thoroughly dry before scanning documents.