Table of Contents
Advertisement
AW4 Series (Rear facing type)
1
Install the umbrella ring following the removal procedure in the reverse order.
Facing the product, install the umbrella ring above the
area where the frame and thin bar jointed on the right
handle.
Wrench
Thin bar
* Make sure to use correct screw. The length of the screws for umbrella ring and umbrella holder are different.
Locking Key and Coin Lock Replacement Procedure <AW3 Series>
In case you find a problem with the keychain or the coin lock
during the daily inspection, we recommend that you purchase a
keychain replacement kit or a coin lock replacement kit and carry
out the replacement following the procedure below.
The tools on the right are
required for this procedure.
Locking Key Removal
1
Remove the red screw cap from the bottom of
the coin lock.
Locking key
Installation
Phillips
screwdriver
Screw M6 x 25
mm
(with a plain
washer and a
spring washer)
Cap nut
Umbrella ring
l Phillips screwdriver
2
Red screw cap
28
2
Install new umbrella holder
Wrench
Nut
(attached to
the holder)
Flange
nut
Screw M6 x 30 mm
(with a plain washer and
a spring washer)
Place the umbrella holder on the other side of
handle side and locate the support slightly outside.
Always inspect the new part after
replacement following the daily
Warning
inspection instructions.
l Precision flat blade screwdriver
Remove the screw.
Umbrella
holder
Phillips
screwdriver
Screw
Advertisement
Table of Contents
