Table of Contents
Advertisement
AW3 Series (Forward facing type)
Pull the bumper strongly toward you to remove it.
AW4 Series (Rear facing type)
Unscrew the 5 screws from the
lower angel and disassemble the
bumper into the lower and upper
parts.
AW4 Series (Rear facing type)
Assemble in the reverse order of the removal.
Umbrella Holder Replacement Procedure
In case you find a problem with the umbrella holder during the daily
inspection, we recommend that you purchase an umbrella holder replacement
kit and carry out the replacement following the procedure below.
The tools on the right
are required for this
procedure.
AW3 Series (Forward facing type)
Remove the umbrella ring and the umbrella holder using the Phillips
screwdriver and the wrench.
Wrench
Cap nut
Removal
Bumper
Removal
Screw
Philips driver
Installation
l Phillips screwdriver
No.2
Removal
Umbrella ring
Phillips screwdriver
Screw M6 x 25 mm
(with a plain washer and a
spring washer)
AW3 Series (Forward facing type)
Push strongly the bumper into the frame.
Bumper
Warning
Screw M6 x 30 mm
(with a plain washer and a spring washer)
Phillips
screwdriver
Umbrella holder
26
Installation
Bumper
Bumper
Always inspect the new part
after replacement following the
daily inspection instructions.
l Wrench (10 mm) ×1
Flange nut
Nut
(attached to the holder)
Wrench
Advertisement
Table of Contents
