Bumper Replacement Procedure - Combi ANGEL WAGON AW Series Instruction Manual And Inspection Manual

Combi ANGEL WAGON AW Series Instruction Manual and Inspection Manual
AW4 Series (Rear facing type)
1
Affix the sticker
Handle part without the boss
Inside of the handle
There are 2 kinds of handle
stickers. The illustration on the
right is ⑧ Handle sticker on
page 12.
2
Assemble the handle in reverse order by inserting to the hole on the frame
Handle (with sticker)
Hole at the
back of frame
3
Clip with handle rings
Handle

Bumper Replacement Procedure

In case you find a damage on the bumper during the daily inspection,
we recommend that you purchase a bumper replacement kit and
carry out the replacement following the procedure below.
Always inspect the new part after replacement
Warning
following the daily inspection instructions.
Installation
● Make sure to insert the handle ring from the lower angle until you
hear the click sound.
* When handle ring is too firm, use soft water plier.
● Make sure not to find any gaps or sharp edge after the assemble
Caution
Handle ring x 2
Outside of the black line
should be folded inside
the handle.
Indicates folding
position
Place the sticker correctly. The handle
rings can not be assembled if the
Caution
sticker is not in the correct position.
There is a boss at the
center of handle
Assemble the handle after the
confirming the direction of sticker is
Caution
correct.
l Make sure the stickers on both side are not the same.
l Use new handle rings enclosed. Old handle rings might
be damaged by the disassembling.
Prepare below for changing the bumper of
AW4 series (rear facing type)
l Phillips screwdriver No.2
25