Special Warnings And Troubleshooting - Asko OP8611S Operating Instructions Manual

Special warnings and troubleshooting

During the warranty period, any repairs may only be performed by service technicians
authorized by the appliance manufacturer.
Before starting the repair, the appliance must be disconnected from the power mains by removing
the fuse or by removing the mains cord from the wall outlet.
Unauthorized tampering and repairs may cause the risk of electric shock and short circuit;
therefore, do not attempt them yourselves. Leave such tasks to an expert or an authorized service
technician.
In case of minor faults or problems with the appliance operation, check the following instructions to
see whether you can eliminate the causes by yourselves.
Important
Sensors do not
respond, the display
has frozen.
The main fuse is
tripped repetitively...
Oven interior lighting
does not work...
The oven does not heat
up...
The pastry is not
cooked thoroughly...
The program timer
shows extraordinary
fi gures or is turned on
and off uncontrolled...
Program timer display
is blinking
40
A visit by a service technician during the warranty period will be
charged if the appliance is not functioning because of improper
use. Store these instructions in a place where they are always
readily accessible; if pas the appliance on to another person, the
instructions should also be included.
Following is some advice on rectifying some common problems.
• Disconnect the cooker from the power network for a few minutes
(remove the fuse or trip the main switch); then, reconnect it to the
power network and turn on the oven.
• Call a service technician!
• The process of replacing the bulb is described in the section
"Appliance part replacement".
• Was the temperature and operating mode selected appropriately?
• Is the oven door closed?
• Have you removed the grease fi lter?
• Did you observe the instructions and tips from the section "Baking
pastry"?
• Did you follow the instructions in the baking table closely?
• In case of faulty operation of the program timer, disconnect the cooker
from the power mains for a few minutes (remove the fuse or trip the
main switch); then, reconnect it to the mains and set the time of day.
• There was a power supply failure, or your cooker was just connected to
the power mains. All set times have been deleted.
• Set the time of day to enable operation of the appliance.
• After the operation has been over, the oven switches off, and clock
fl ashes. Take the dish from the oven and turn the clock off.