Safety Instructions - tams elektronik FCS Series Manual

English

electronic tin solder (0.5 mm diameter)

connecting wire, e.g. enamelled copper wire

LEDs for the vehicle´s lighting. Depending on the vehicle´s size and
construction you can use for example the following:
SMD LEDs type 0402, 0603, 0805 oder 1206 or
wired LEDs 1,8 mm

when connecting white LEDs as front lights to the modules FCS-1,
FCS-3 or FCS-4: 2 series resistors with 100 W

2. Safety instructions

Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards

Touching powered, live components,

touching conducting components which are live due to malfunction,

short circuits and connecting the circuit to another voltage than
specified,

impermissibly high humidity and condensation build up
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:

Never perform wiring on a powered module.

Assembling and mounting the kit should only be done in closed,
clean, dry rooms. Beware of humidity.

Only use low power for this module as described in this manual and
only use certified transformers.
Page 6
FCS modules