tams elektronik FCS Series Manual page 12

English FCS modules
Dim switch (FCS-2 only)
Depending on the ambient lighting, the lighting of the vehicle is
switched on and off via a light sensitive switch. The sensitivity of the
switch is set via a trimpot.
Flashing lights (FCS-1 and FCS-4)
The FCS-1 has 5 outputs, the FCS-4 two outputs for the connection of
orange or blue LEDs as flashing lights.
Warning lights (FCS-3 only)
There are two outputs for the connection in series of LEDS as warning
lights on the right and the left side. The function is adapted to the use
in (urban) busses. It is not possible to switch the warning lights when
the vehicle is turning.
Siren (FCS-4 only)
The output for the loudspeaker is switched on and off in short intervals
while the vehicle is in motion and generates the typical signal.
Motor control / acceleration delay (FCS-2 to FCS-4)
After starting, the motor voltage will be increased gradually, so the
vehicles starts gently.
Motor control / braking delay (FCS-2 and FCS-3)
When mounting an additional reed contact into the vehicle it is possible
to realise a braking delay. When crossing the stop with the first reed
contact the motor voltage is reduced and the vehicle brakes. After
crossing the stop with the second reed contact the vehicles stops.
During the brake application the braking lights are switched brighter.
Page 12