tams elektronik FCS Series Manual page 21

FCS modules
Connection of the LEDs for the flashlights
Connect the anodes (+) of the LEDs to the soldering points X4 to X8
and the cathodes (-) to the soldering point X3. Note the different
functions of the outputs. Additional series resistors are not necessary
for the operation of the LEDs for the flashlights.
When you want to run program 2 ("Alternating flashlight") you have to
make a connection between the soldering points X9 and X3. Otherwise
the program 1 ("Double flashlight") is performed.
X3
X4 LED1
X5 LED2
X6 LED3
X7 LED4
X8 LED5
X9
Programm 1
"Double flashlight"
Voltage output (-)
of the circuit
Double flashlight
Double flashlight
Alternating
double flashlight
Double flashlight
Input of the circuit
à open
Programm 2
"Alternating flashlight"
Voltage output (-)
of the circuit
Alternating
double flashlight
Alternating
flashlight
Flashlight
Input of the circuit
à connected to X3
English
Page 21