Table of Contents
Advertisement
TOOL AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Utility knife
Scissors
Push-pin
Isopropyl alcohol
Shop towel
Tape measure
Drill
3 mm and 8 mm Drill bits
1-1/8" (28 mm) Hole saw
Ratchet
5 mm Combination wrenches
8 mm, 10 mm, and 14 mm Sockets
8 mm, and 10 mm Combination wrenches
Tape
Masking tape
Torque wrench
T25 Torx wrench
Diagonal cutters
Eye protection (face shield, safety goggles, etc.)
Illustration of the DVD i-VES Installed in the Vehicle
i-VES
HARNESS
DIN
CABLE "B"
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
DIN CABLE "A"
MONITOR
CONSOLE
INTERIOR
LIGHT
HARNESS
DVD PLAYER
4917091H
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
3.
Insert a flat-tip screwdriver wrapped with a shop
towel into the groove of the instrument panel and
release two clips. Pull the instrument panel out
toward you to release eighteen clips, and remove
the instrument panel by unplugging the vehicle
connectors.
VEHICLE
CONNECTOR
VEHICLE
CONNECTOR
CLIPS (18)
AII 32445 (0605)
VEHICLE
CONNECTOR
INSTRUMENT
PANEL
SHOP
TOWEL
CLIPS (2)
FLAT-TIP
SCREWDRIVER
3915101T
Insert into the
groove.
3 of 24
Advertisement
Table of Contents
