Honda 08B23-SJC-100 Installation Instructions Manual page 20

74. Using isopropyl alcohol on a shop towel, clean the
area where the cushion tape will attach. Using
scissors, cut one cushion tape in half. Secure the
interior light harness to the headliner with one half
cushion tape.
CUSHION TAPE
Cut in half.
HEADLINER
OPENING
INTERIOR
LIGHT
FRONT
HARNESS
75. Position the 3-pin connectors in the cavity in the
headliner. Reinstall the rear interior light.
76. Using isopropyl alcohol on a shop towel, clean the
areas where the cushion tapes will attach. Using
scissors, cut three cushion tapes in half. Secure
DIN cable "A" to the headliner with six pieces of
cushion tape.
FRONT
20 of 24
INTERIOR
LIGHT
OPENING
FOAM
BLOCK
3-PIN
CONNECTOR
CUSHION
TAPES (3)
HEADLINER
Cut in half.
OPENING
250 mm
DIN
CABLE "A"
Installing the Monitor Console
77. Using isopropyl alcohol on a shop towel, clean the
areas where the EPT sealers will attach. Using
scissors, cut three EPT sealers in half. Attach the
EPT sealer halves to the monitor bracket in the
areas shown. Cut the excess off the EPT sealers.
Cut off.
MONITOR
BRACKET
78. Secure the monitor bracket to the vehicle frame
with four 6 x 12 mm washer-screws.
VEHICLE
FRAME
FRONT
4916152H
AII 32445 (0605)
EPT SEALERS (3)
Cut in half.
Cut off.
Cut off.
MONITOR
BRACKET
6 x 12 mm
WASHER-
SCREW
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
Cut off.
4916173H
HEADLINER
OPENING
4916182H