38. Route the i-VES harness, DIN cable "A" and DIN
cable "B" toward the rear of the vehicle.
i-VES
HARNESS
39. Slide the center console cup holder forward, and
slide the inner cover forward. Open the console
cover.
INNER
COVER
CUP
HOLDER
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
DIN
CABLE "B"
VEHICLE
FRAME
DIN
CABLE "A"
CONSOLE
COVER
CENTER
CONSOLE
40. Position template A on the center console at the
location shown, and attach template A to the
center console using strips of tape.
CENTER
CONSOLE
41. Using a push-pin, mark the center console at the
marks on the template. Remove the template.
42. To the prevent drilling through the inner panel,
4915044H
wrap tape around the end of a 3 mm and an 8 mm
drill bit about 15-20 mm away from the tip.
15-20 mm
DRILL BIT
43. While wearing eye protection, drill an 8 mm hole at
each marked point. Start with a 3 mm drill bit and
4915050H
finish with an 8 mm drill bit. Remove any burrs
from each hole.
AII 32445 (0605)
TEMPLATE A
TAPE
PUSH-PIN
MARK
TAPE
(Wrap tape around
the drill bit)
4915060H
CENTER
CONSOLE
DRILL BIT
(3 mm
8
mm)
DRILL
4915070H
13 of 24