Tabs; Glove Box - Honda 08B23-SJC-100 Installation Instructions Manual

68. At the glove box opening, secure DIN cable "A" to
the vehicle harness with three wire ties.

GLOVE BOX

OPENING
WIRE TIE
69. Using isopropyl alcohol on a shop towel, clean the
area where the cushion tape will attach. Secure
DIN cable "A" to the vehicle panel with one
cushion tape.
VEHICLE CLIP
VEHICLE
HARNESS
DIN
CABLE "A"
CUSHION
TAPE
70. Secure DIN cable "A" to the vehicle harness with
two wire ties, and tighten the wire tie you
temporarily secured to DIN cable "A" in step 32.
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
VEHICLE
HARNESS
DIN
CABLE "A"
4D13050H
WIRE
TIE (2)
DIN
CABLE "A"
VEHICLE
PANEL
WIRE TIE
(Fasten securely)
4916102H
AII 32445 (0605)
71. Remove the rear interior light.
• Remove the two lenses (four tabs on each
lens).
• Remove the two self-tapping screws.
• Unplug the vehicle 3-pin connector.
VEHICLE 3-PIN
CONNECTOR

TABS

(4)
72. Route the interior light harness between the
headliner and insulator from the interior light
opening, and out the headliner opening.
INTERIOR
LIGHT
HARNESS
HEADLINER
HEADLINER
OPENING
VEHICLE
FRAME
FRONT
73. Plug the interior light harness 3-pin connector into
the vehicle 3-pin connector.
REAR
INTERIOR
LIGHT
SELF-TAPPING
SCREWS (2)
LENS FRONT
4916111H
INSULATOR
INTERIOR LIGHT
OPENING
VEHICLE 3-PIN
CONNECTOR
INTERIOR LIGHT
HARNESS 3-PIN
CONNECTOR
4916122H
19 of 24