Makita CL106FD Instruction Manual page 5

Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
► 1 . Switch trigger
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp, pull the switch trigger. During the
tool actuating, the lamp turns on.
Release the switch to turn off the lamp.
1
► 1 . Lamp 2. Switch trigger
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Disposing of dust
CAUTION:
1
becomes too full, or the suction force weakens.
CAUTION:
cleaner itself of dust. Failure to do so may cause the
ilter to be clogged or the motor to be damaged.
In order to drop dust sticking on the ilter in the capsule,
tap the capsule 4 or 5 times with your hand.
► 1 . Capsule 2. Suction inlet
Point the suction inlet downwards, turn the capsule in
direction of the arrow as illustrated, and disconnect the
capsule slowly and straight.
2
1
► 1 . Capsule 2. Suction inlet
NOTE: Be sure to set a garbage bag beneath the
capsule, as dust may spill out when the capsule is
opened.
Remove accumulated dust from inside of the capsule
and off of the preilter.
5 ENGLISH
Always be sure that the tool is
Empty the cleaner before it
Be sure to empty the inside of the
2
1
2